Interior office sound dividers

The track of the movable wall divider sliding is installed on the ceiling, there is no track on the ground, no ground track is suspended, but it is more stable and reliable. The movable partition wall is generally made of PAR sound-absorbing glass fiber Sound Insulation cotton, and the partition wall door panel is surrounded by an all-inclusive aluminum frame, the board is made of melamine board, and the board is sandwiched with sound insulation cotton. Melamine board has relatively good fire performance, and this board is available in a variety of colors and styles. Through proper craftsmanship, the entire wall can be flexibly and conveniently retracted through the track. Check. When accepting movable partitions, first check whether the rails of the movable partitions are firmly connected and whether the positions are closely overlapped; whether they can feel safe, stable, and sensitive when pushing and pulling, and push and pull several times, as long as any inappropriate jam occurs. It should be pointed out to communicate effectively with the installer to solve the problem, observe whether the wall is smooth and smooth, and use the touched wall to experience the hand feel. If there is a sticky or uneven place, manual grinding and optimization should be required; and the last point is to ensure the activity The partition wall remains noise-free when pushed and pulled.

Need to pay attention to the following problems in the maintenance of mobile partitions:

1.The facade is uneven and uneven, you can make corresponding adjustments according to the finish. Measure with a spirit level on the partition surface. Be careful to leave a gap of about 10mm.

2. The wall divider sliding is unstable and cannot be too close, so a certain distance should be maintained between the partition doors. Use a thin line to level the side of the movable partition. Prepare glue during the maintenance process. After the maintenance is completed, clean the surface of the partition.

3. When repairing the partition door, be careful not to damage the door.

4. When installing the card slot plate, remember that the card slot plate cannot be installed too tightly, and it is generally successful if it can be stuck.